![]() ![]() Choose the media you would like to view from the menu on your device and play as you normally would.Some devices may not have this ability, but they can still be used with the projector to project videos, photo slide shows, and some app content (this functionality is app dependent). NOTE: After syncing with the projector you may see your device’s screen being mirrored by the projector. Allow the projector 15 to 20 seconds to fully start up and sync with your device.Power on the projector by flipping the power switch to the on position.If no external speaker is connected, the projector’s internal speaker will be used for audio. Audio out (3.5mm) - Connect an external speaker or headphones. Volume Controls - Increase (+) or decrease (-) the volume output of the projector. If desired, connect a speaker to the 3.5mm audio out jack. Locations of Parts and Controls Projector Lens Focus Wheel - Roll the focus wheel forward and backwards to fine-tune the projected image.NOTE: Some devices may require an adapter to connect to your device. Connect the included HDMI cable to the HDMI port on the projector and the other end to your device.To power the projector with the built-in battery, simply turn the projector on.Once connected, the power indicator light will illuminate red on the projector to show it is connected to power. IMPORTANT: Fully charge the battery before the first use (approximately 3-4 hours). Once you have the correct number displayed, press the volume down - button to confirm the number entered. Press the volume up + button to scroll through numbers from 0 to 9. ![]() These buttons are located on the side of the projector. The blue system indicator light will come on if the battery power is getting low. Digits are entered using the volume up + and volume down - buttons on the projector. To power the projector with the Micro USB to USB cable, connect the Micro USB to the projector’s and plug the other end into a USB port. Charging the Battery The built-in battery is charged using the included Micro USB to USB cable.The projector can be powered using the included Micro USB to USB cable or the built-in battery.IMPORTANT: Fully charge the battery before the first use (approximately 3-4 hours). The blue system indicator light will come on if the battery power is getting low. The built-in battery is charged using the included Micro USB to USB cable. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy & Safety How YouTube works Test new features NFL Sunday Ticket Press Copyright. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |